Henny Penny Velocity OXE-100, Инструкции по эксплуатации

Страница: 73 / 118

Programming
61
T Ta ab blle e 8 8--3 3 F Fiilltte err S Se ettttiin ng gss
Program
Code
Display Description
Q Qu uiicckk F Fiilltte err S Se ettttiin ng gss
IIN NF FO O:
• The Start-up Mix and the Cook Mode Auto Mix operations are specialized versions of the Quick Filter,
and share some of the Quick Filter programmable parameters. For example, both of the Mix operations
use the Quick Filter’s Max Pump Time setting.
• For very thin (low viscosity) cooking oils, drain opening setting may need to reduce from the default value
and you might need to reduce the drain opening setting from the default value.
• For 50 Hz systems, or if the control routinely gives up before the pot is refilled, you might need to
increase the max pump time from the default value–50 Hz pumps may run more slowly than 60 Hz
pumps.
These parameters control the Quick Filter operation. The Quick Filter has three basic steps:
1 1.. DROP - Opens the drain and drops the oil level by a certain amount. Depending on settings, may drop
the oil level just a few inches during this phase, or could drain the entire pot.
2 2.. FILTER - Runs the filter pump with the drain partially open for a given time, pumping the oil through the
filter paper to clean the oil. This operation typically holds a relatively constant oil level in the pot.
3 3.. FILL - Closes the drain fully and runs the filter pump to refill the pot. Watches for a temperature rise on
the upper temperature probe (level probe) to indicate that the pot has refilled. Runs the pump a bit longer
to get the last of the oil out of the drain pan, then turns the pump off.
FC-1 FILTER TRACKING MODE There are two options, GLOBAL and MIXED MODE.
• GLOBAL - If selected, continue at FC-1A.
• MIXED - If selected, skip FC-1A, and then go to
Product Programming mode to specify the filter
cycles allowance for each individual product.
Refer to Chapter 8 Programming
, page 49 .
A new Info button status screen has been added to
display how many cook cycles remain before the next
auto-filter is activated if Global mode, or to indicate
the current accumulated filter usage as a percent, ac-
cumulating up toward 100% – at which point the next
auto-filter is activated if Mixed mode.