Henny Penny LVE-202, Техническое руководство

Страница: 48 / 115

Maintenance
36
7 7..4 4..1 1 C Co on nttrro oll P Pa an ne ell R Re ep plla acce em me en ntt
1 1))
Remove electrical power supplied to the vat.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff
a an nd d d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,,
o orr u un np pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
2 2))
Support control panel with one hand, loosen retaining screw at panel top, slide
panel down enough to clear screw. Push panel back up, then swing top out and
down.
3 3))
Unplug connectors on back of control panel.
4 4))
Support control panel bottom with one hand, swing panel top up about 90°, let
panel slide down until hinge tabs come out of shroud slots and remove panel.
5 5))
Install new control panel by inserting hinge tabs in slots.
6 6))
Plug connectors into back of control panel per label on panel.
7 7))
Support control panel bottom, swing panel top up about 90°, slide panel down
slightly to clear screw head, push panel top up to engage screw, then tighten
screw.
8 8))
Connect power and check operation of unit.
7 7..4 4..2 2 M Me en nu u C Ca arrd d R Re ep plla acce em me en ntt
1 1))
Perform steps one and two of 7.4.1
Control Panel Replacement, page 36
.
2 2))
Loosen tape securing card at ride side of control panel and pull card from panel.
Carefully slide new menu card back into panel slot and secure with tape.