Henny Penny LVE-202, Техническое руководство

Страница: 26 / 115

Level
1
Programming
14
9 9))
Press the down arrow until “COOK ID” shows in the display along with the
product ID. For example, “NUG” would be the ID for nuggets. Use the product
buttons to change the ID, following the same procedure as Step 6 above.
A Alla arrm mss ((D Du uttyy 1 1 & & 2 2))
1 10 0))
Press the down arrow until “DUTY 1” shows in the left display, and an alarm
time in the right display. Press the product buttons to set an alarm. Ex., If a Cook
Cycle was set at 3 minutes, and an alarm was to go off after 30 seconds into the
Cook Cycle, “0:30” would be set in the display at this time. When the timer
counts down to 2:30 the alarm sounds. After the alarm time is set, press the
down arrow and “DUTY 2” shows in the display, and a second alarm can be
programmed.
Q Qu ua alliittyy T Tiim me err
1 11 1))
Press the down arrow until “QUAL TMR” is displayed along with preset holding
time. Press product buttons to adjust holding time, up to 2 hours, 59 minutes.
A AIIF F D Diissa ab blle e
1 12 2))
Press the down arrow until “AIF DISABLE” shows in the display along with
“YES” or “NO”. Using the left and right arrows, change the display to “YES” if
that product is to not be included in the automatic intermittent filtration operation,
or “NO” if it is to be included.
A Assssiig gn n B Bu utttto on n
1 13 3))
Press the down arrow until “ASSIGN BTN” shows in the display, along with the
product (ex: NUGGETS). If this product already has a product button assigned
to it, that LED will be lit. To assign other product buttons to that product, press
and hold the product button for 3 seconds and that LED stays lit. To remove a
product from a button, press and hold the product button with a lit LED and the
LED goes out.
3 3..2 2 A AIIF F C Cllo occkk
This feature allows the controls to be set for periods of the day that block the
automatic “Filter Now” prompts. For example, the controls could be set to not interrupt
with “Filter Now” prompts during the lunch rush, and during the supper rush. But, if
filtering is desired during this time, press and hold a filter button to access the filter
menu.
Each AIF Blocking period is defined by a start time (a time of day, XX:XX A, etc) and a
duration in minutes.
Weekdays M-F are all grouped together. Up to four different AIF blocking periods may
be programmed throughout the day for Monday - Friday. (All days share the same
settings.)
A separate set of four blocking periods may be programmed for Saturdays, and a final
set of four blocking periods may be programmed for Sundays.
1 1))
Press and hold the temp and info button until “LEVEL - 1” shows in the display,
followed by “ENTER CODE”.
2 2))
Enter code 1, 2, 3, 4 (first 4 product buttons). “PRODUCT” and “SELECTN”
show in the displays.