Henny Penny LVE-202, Техническое руководство

Страница: 61 / 115

Maintenance
49
Figure 7-1 Probe Assembly Install
1 11 1))
Push temperature probe through until it makes contact with gauge.
1 12 2))
Tighten temperature probe in place.
E Exxcce essss ffo orrcce e w wiillll d da am ma ag ge e tte em mp pe erra attu urre e
p prro ob be e.. H Ha an nd d--ttiig gh htte en n n nu utt a an nd d tth he en n 1 1//2 2
ttu urrn n w wiitth h a a w wrre en ncch h..
1 13 3))
With locking tab up, insert pin into connector opening and visually check that tab
is fully engaged. Fasten connector to control panel.
1 14 4))
Support control panel bottom with one hand, swing panel top up about 90
degrees, slide panel down slightly to clear screw head, push panel top up to
engage screw, then tighten screw.
1 15 5))
Reconnect power to vat and fill vat with oil.
7 7..1 10 0 O Oiill L Le evve ell P Prro ob be ess
The oil level probes monitor the oil level by temperature differences. If they become
disabled, the display shows “E-18A” - left probe; “E-18B” - right probe; “E-18C” - both.