Hand
Model
Instruc
JT-S
You sho
Read th
After re
Safety p
Do not
Importa
Follow
Importa
Follow
Pro
Pro
Do not use
Do not allow
1-3 Komaba-cho, Nakatsugawa City, Gifu Prefecture, Japan
If you think something has gone wrong?
Perform the following checks and fixes.
Problem
Check
Fix
Turn the ground-fault circuit interrupter on.
Turn the power switch on.
Place hands all the way in.
Turn OFF the power switch. After the power lamp at
the display has turned off, remove foreign substances
or fouling. Wait at least for 40 seconds and then turn
the power switch to ON again.
Turn the power switch off, check that all the lamps in
the display have gone off (around 40 seconds), and
then turn the power back on.
Turn the heater switch to ON .
Are you putting your hands in all the way?
Are any lamps in the display on?
Has a blackout occurred?
Is the sensor blocked by dirt or dust?
Hasn t the power switch been turned on while
hands are inserted in the hand-drying area?
No air blows even if hands are
inserted
Air does not stop blowing
Isn t the black wall area fouled in white in the
hand-drying area?
Isn t the heater switch turned OFF ?
No hot air comes out
Any problems with the power supply will cause
the lamp to go on or flash.
Check lamp is flashing
If the above fixes do not work, turn off the power and the ground-fault circuit interrupter and have your dealer
inspect and if necessary repair the unit. (Costs are as per agreement with dealer.)
This is due to oil and dust accumulated on the heater burning, and is not a malfunction.
Specifications
JT-SB216ESH-W-CE
●
The drain tank capacity is 0.8
R
.
Model
Voltage
Frequency
Power input
(W)
1010-1200
50-60Hz
Current
(A)
Weight
(kg)
4.6-5.0
220-240V
14
Dimensions (W
D
H)
300
222
835 (
mm)
During initialization, smoke and odors
emanate from the hot air outlet vent.
JT-SB216ESH-IB_874HC1201-GB 06.12.9 2:18 PM ページ 1
