16
STEP 6CS – No Hard Water Bypass Enabled
- Use
or
buttons to select
NO HARD WATER BYPASS ENABLE. Selection requires that a connection to
a Motorized Alternator Valve (MAV) is made to the two pin-connector labeled
ALTERNATOR MAV DRIVE located on the printed circuit board. The MAV will be
driven closed before the first regeneration cycle that is not FILL or SOFTENING or
FILTERING, and be driven open after the last regeneration cycle that is not FILL.
NOTE: If the control valve enters into an error state during regeneration mode, the
no hard water bypass valve will remain in its current state until the error is corrected
and reset. Reset by pushing NEXT & REGEN buttons simultaneously until display
changes. Press NEXT to go to Step 10CS.
STEP 7CS –
Configuring the Control Valve for Separate Source Operation
-
Select Separate Source Enabled for control operation. For separate source opera
-
tion, the three wire connector is not used. Selection requires that a connection to a
MAV is made to the two pin connector labeled ALTERNATOR MAV DRIVE located
on the printed circuit board. The C port of the MAV must be connected to the valve
inlet and the A port connected to the separate source used during regeneration. The
B port must be connected to the feed water supply. When set to Separate Source
Enabled the MAV will be driven closed before the first regeneration cycle, and be
driven to open after the last regeneration cycle.
NOTE: If the control valve enters into an error state during regeneration mode, the
MAV will remain in its current state until the error is corrected and reset. Reset by
pushing NEXT & REGEN buttons simultaneously until display changes.
ENABLED
NO HARD BYPASS
SET
STEP 6CS
SEPARATE SOURCE
SET
STEP 7CS
ENABLED
➔
➔
