HEIDENHAIN TNC 640, Руководство пользователя, Страница: 265 / 948

Tools | Tool data
6
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
265
The control saves the tool usage times in a separate file with the
extension
pgmname.H.T.DEP
. This file is not visible unless the
machine parameter
dependentFiles
(no. 122101) is set to
MANUAL
There are two ways to run a tool usage test for a pallet file:
If the cursor in the pallet file is on a pallet entry, the control runs
the tool usage test for the entire pallet.
If the cursor in the pallet file is on a program entry, the control
runs the tool usage test only for the selected program.
Using a tool usage test
Before starting a program in the
Program Run, Full Sequence/
Single Block
operating modes, you can check whether the tools
being used in the selected program are available and have sufficient
remaining service life. The control then compares the actual
service-life values in the tool table with the nominal values from the
tool usage file.
Press the
TOOL USAGE
soft key
Press the
TOOL USAGE TEST
soft key
The control opens the
Tool usage test
pop-up
window indicating the result of the usage test.
Press the
OK
soft key
The control closes the pop-up window.
Alternative: Press the
ENT
key
You can query the tool usage test with the
FN 18 ID975 NR1
function.