heat-timer ETV Platinum Plus, Инструкция по установке и эксплуатации

Страница: 34 / 56

34 ETV Platinum Plus Installation and Operation Manual
059305-00 Rev. D Heat-Timer Corp.
Default Display
The ETV Platinum Plus default display varies depending on selected Control Mode and alarm
condition.
NOTE: When in the ETV + TMC mode, the area above the variable function buttons that describe the button’s
function may not be displayed due to inactivity. Pressing the far-right button in the default display will enter
into the Menu screen.
Display Icons and Message
s
The following icons and messages may be displayed by the ETV Platinum Plus.
ETV Mode TMC Mode ETV + TMC Mode
# Mode Message Description
1 All The battery icon blinks when the battery is weak.
2 TMC TMC Limit = 160°F
Valve Close! See
Log
The alarm is set to be triggered when the system temperature
exceeds the displayed setting for the specified Delay Alarm period.
See “TMC Setpoint” on page 45 .
The system temperature exceeded the alarm limit. TMC lockout
has occurred (the control closed the TMC valve). View the alarm
logs (see “Alarm Log” on page
50
).
When in the ETV + TMC mode, this message will alternate with
the “TMC Limit = 160°F” message.
3 TMC Valve Open The system temperature is below the alarm limit (TMC Alarm is
not triggered). The control opened the TMC valve.
4 ETV No Flow! The Flow Switch option is enabled and no flow is detected. See
“Wiring the Flow Prove” on page 27 .
5 TMC TMC Lockout
Alarm When a TMC Lockout occurs, “TMC Lockout” blinks.
When an active alarm occurs, “Alarm” blinks.
6 All Target Temperature
EMS Open/Short The control target temperature setting.
When EMS is used and the signal fails, “EMS Open/Short” is shown.
7 All Value or Switch Icon When Aux 1 is configured as Temperature input, the value is shown.
When Aux 1 is configured as Switch, the switch status icon is shown.
8 All Value or Switch Icon When Aux 2 is configured as Temperature input, the value is shown.
When Aux 2 is configured as Switch, the switch status icon is shown.
9 All
Communication
Lost!
Internet Communication (ICMS) option only.
The control is set to communicate over a network and communication
is not detected. This message will alternate with the date and time
message.