HBM WE2108 Series, Справочное руководство

Страница: 43 / 72

43
WE2108
HBM A1632-2.0 en
•
Press ENTER to store the value. donE appears as confirmation.
4. Calibration weight:
•
To calibrate the nominal load, either a calibration weight equal to the
scale nominal load ”CAP 1” is used, or a part load calibration is per-
formed (see next section).
•
Check and if necessary change the ”LOAd1” parameter: It must be equal
to the calibration weight used.
•
Place the calibration weight on the scale.
•
Call up ”CAL−1” parameter, the previous calibration value is displayed
with
ENTER .
•
Pressing ENTER again starts the measurement. buSY appears in the dis-
play.
•
When the measured value appears the measurement is completed. The
value is displayed in mV/V (2,0000 = 2 mV/V).
•
Press ENTER to store the value. donE appears as confirmation.
Cancellation is possible at any time with CE . In this way the just called up
parameter (only this!) is reset to the previous value. The old value is deleted
only after storage (donE display).
6.1.3 Part load calibration
A part load calibration can be performed if no calibration weight of the size of
the scale nominal load ”CAP 1” is available. For this purpose set the ”LOAd1”
parameter to the value of the calibration weight used. This may be in the
range of 20%...120% of the scale nominal load. ”LOAd1” is scaled like the dis-
play value, e.g. 2 kg = 2,000 (with 3 places after the decimal point).
If no calibration has been performed as yet, ”LOAd1” is equal to ”CAP 1”.
Before the calibration the ”CAP 1” parameter (
Func menu) must be set to the
scale nominal load!
6.1.4 Setting for legal for trade
The following settings serve to protect the calibration performed: (see
Section 6.6
”Access authorization”also)
Submenu Parameter Meaning Values
Func trAdE Scale standard 0: Industrial mode
1: OIML
2: NTEP
LocPA Locking against
unauthorized changes 0: All menus unlocked
1: Calibration menu locked