Pump Capacity -
Set the minimum and maximum RPM of the pump.
Refer to your pump manual for more information.
Permitted User Setting -
The OmniPL will automatically calculate
these values based on the minimum and maximum RPM that were
previously entered. They can be changed as desired.
Speed Presets -
Set the Low Pump Speed %, Medium Pump Speed
%, and High Pump Speed %, presets. These presets will be used
when setting schedules for your pump.
Would You Like to Enable Priming?
Select whether you want the
pump to prime when turned on. This will turn the pump on at high
speed for 3 minutes to establish normal water flow every time the
pump is activated after being off for at least 30 seconds.
Does Cleaner have a Valve?
Select whether the cleaner requires a valve to change posi-
tion when in use.
If Yes is selected:
How Many?
Select how many valves are used for the cleaner.
Where is the Valve(s) Wired?
Selecting the box will bring you to a table show-
ing all detected low voltage relays. Select the relay(s) that is wired to the clean-
er valve(s), then advance. The valve(s) should now be shown in the box(es).
Advance to the next screen to continue cleaner configuration.
Would you like your valve(s) to cycle On and Off at a set interval?
If you
would like the cleaner valve(s) to cycle to a set interval while cleaning, select
Yes. Set the interval on the next screen.
Freeze Protection Enabled?
Freeze protection is used to protect the pool and plumbed
equipment against freeze damage during cold temperatures. If freeze protection is en-
abled AND the air temperature falls below the freeze threshold (refer to pump configura-
tion), the OmniPL will turn on the cleaner pump to circulate the water.
How Many Water Features?
- This question is for THIS BODY OF WATER ONLY. For example: If you
have 2 water features; one for the pool Body of Water and one for the spa Body of Water, you would
answer “1” to this question.
If “1”or more is selected:
Select and Configure a Water Feature
At this screen you can add, delete and configure
your water features. Select the desired water feature, then touch the Advance button.
When finished configuring water features, you’ll be returned to this same screen. Touch
the Done button and advance to the next section of configuration. Refer to the following
information when configuring water features:
Type of Water Feature?
Touch the box and select the type of water feature used. Choic-
es are Water Feature, Water Slide, Waterfall, and Fountain.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
40