As you advance through the second Body of Water’s configuration settings, note that most of the
questions asked are the same as the first Body of Water with the exception of the following:
Does Body of Water 2 share its equipment with Body of Water 1?
If Yes is selected:
Your system will be “fully shared” which means your filter pump/heaters/chemistry will be
shared between both Bodies of Water. You can now set your filter pump and heater settings
for this body of water.
If No is selected:
You will begin dual equipment setup for you second Body of Water. This means that your filter
pump and chemistry will not be shared between both Bodies of Water, but you will still have the
option of configuring shared heaters and spillover. You can now configure a filter pump and
heaters for this body of water.
Are any of Body of Water 2’s heaters shared with Body of Water 1?
If Yes is selected:
Which body of water is heated in the event that both are running?
Select the Body of
Water that you would like to have heating priority if both Bodies of Water are running. This
question only appears if you have a Pool/Pool or Spa/Spa setup. If you have a Pool/Spa setup,
then the Spa Body of Water will automatically have heating priority.
Select Shared Heater Valves -
Select Body of Water 1’s return valve, Body of Water 2’s re-
turn valve, and the Heater return valve in your system. The selections will also affect spillover
operation.
Select the heaters you wish to share -
Select the heaters that you configured in Body of
Water 1 that you would like to be shared with Body of Water 2 and press advance.
Does this body of water have any additional heaters?
Select whether you have any ad-
ditional heaters in Body of Water 2 that you would like to configure that are not shared with
Body of Water 1.
Do you have Spillover?
Select yes to this question if you have Spillover in your system. If yes is
selected, choose the valves that will operate Spillover from the following screen.
NOTE: The remaining configuration settings are not specific to a Body of Water.
Do You Have an Air Temperature Sensor?
Select whether there is an air temperature sensor wired
to the OmniPL.
If Yes is selected:
Where is the Sensor Wired?
Touching the box will bring you to a table showing all detected sensors connections. Se-
lect the sensor connection used for the air sensor (typically SENS2) and touch the Done
button. The sensor connection should now be shown in the box and you can advance to
the next screen to continue configuration.
45
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS