12/19
Model 9035
Page 19 of 26
Step 26:
Install one (1) Roof End Support onto the exposed section of pipe at the right front corner of the unit.
Slide the left side roof end support to the front of the unit. Rotate both roof end supports such that the swivel tee
thru holes
’ axes are roughly aligned and the swivel tees mate. (See Figure 23.) Tighten the swivel tee set
screws at the
49.12” pipes.
FIGURE 23
Step 27:
Insert
one (1) 49.12” Pipe into the end support swivel tee thru holes at the roof apex. (
Note: It may be
necessary to loosen some swivel tee setscrews and tee set screws to allow the pipe to slide through freely
.)
Continue to slide the pipe thru the center support swivel tee thru holes moving rearward - loosening and aligning
as needed - until the pipe slides easily through the front end and center support tees. (See Figure 24.)
FIGURE 24
Step 28:
Slide the
49.12” pipe to the rear and through the end support swivel tee thru holes. (See Figure 25.)
Tighten the setscrews at the roof-top
49.12” pipe. (
Re-tighten any loosened set screws.)
FIGURE 25
49.12” Pipe
End Support
Thru Holes
49.12” Pipe
(Exposed End)
Roof End Support
2X Swivel Tee Thru Holes
End Support
Thru Holes
1X 49.12” Pipe
Center Support
Thru Holes
