Harris Intraplex HD Link RF, Руководство по установке и эксплуатации

Страница: 139 / 181

5 – Web Browser Interface Configuration & Operation HD Link Installation & Operation Manual
Version 2, April 2010
Harris Corporation 5-35
Intraplex Products
2. To change the location of the dialog box on your monitor screen, click and hold and drag
the dialog box as desired.
3. Type the IP address .
4. Click an Interface option: HD or LAN .
5. Click Add Address to record this address on the IP Access List .
6. Click Close or to exit the dialog box.
STL Access List
The STL Access List is used to restrict the traffic allowed over the RF link between the transmitter
and the receiver. When a return path is present, the list can also be used to restrict traffic allowed
over the return path from the receiver to the transmitter. When entries are added to this list, they are
prioritized according to the High or Low priorities you set. All high priority traffic is allowed first and
then, if any bandwidth remains, low priority traffic is allowed. If you only enter High priorities on this
list, all other traffic is considered low priority.
Destination : Receiver’s IP address.
Source : Sender’s IP address.
Priority : Priority to assign to the packet when transmitting it between the transmitter and receiver
systems.
Add an address : Click to access the Add an IP Address dialog box (Figure 5-27).
Note: If you do not enter priorities on the STL Access List , the system defaults all traffic coming
into the HD port as high priority and all traffic coming into the LAN port as low priority.
To add an address to the STL Access List , perform these steps:
1. Click at the top right of the IP Access List . The Add an IP Address dialog box appears
(Figure 5-29).
Figure 5-29. STL Access: Add a Destination Dialog Box
2. To change the location of the dialog box on your monitor screen, click and hold and drag
the dialog box as desired.
3. Type the Destination IP address .
4. Type the Source IP address .
5. Click a Priority option, High or Low , for packets transported on this network path.
6. Click Add Address to record this address on the IP Access List .
7. Click Close or to exit the dialog box.