PL0004-01001
+
–
+
–
+
–
+
–
+
–
PL0004-01001
LEFT
SUB
LFE OUT
+ –
+ –
+
–
+ –
+
–
+ –
+
–
RIGHT
SURROUND
FRONT
CENTER
88
9
Use this installation method for receivers and preamp/processors that have a dedicated
subwoofer output with low-pass filtering (also called bass management). If the dedicated
subwoofer output does not have low-pass filtering, follow the instructions in
Connecting
the Subwoofer to a Receiver or Preamp/Processor With Line Outputs,
on page 9.
Use the LFE (purple) connector of the supplied combination LFE and trigger cable to
connect the HKTS200SUB’s
Line-Level LFE In Jack
5
to the dedicated subwoofer output
(or LFE output) of your receiver or preamp/processor.
Connect each satellite speaker and the center speaker to the corresponding speaker
terminals on your receiver or amplifier.
In your receiver or preamp/processor’s setup menu, configure it for
Subwoofer ON
, and
set the front left, front right, center, and surround speakers to
Small
. After you have made
and verified all connections, plug the HKTS200SUB’s
AC Power Cord
8
into an active AC
outlet.
Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output
Left Front
Receiver
Left
Surround
Right
Surround
Subwoofer
Center
Right Front
Front Left
Speaker Cable
(White Bands)
LFE/Trigger Cable
(Purple Ends)
Surround Right
Speaker Cable
(Gray Bands)
Surround Left
Speaker Cable
(Blue Bands)
Center
Speaker Cable
(Green Bands)
Front Right
Speaker Cable
(Red Bands)
0165CSK - HK HKTS20 and HKTS30 v6.indd 8
08/10/09 13:32:03
