Hardi NAVIGATOR 3000, Руководство оператора, Страница: 89 / 122

6 - Maintenance
87
10 Hours Service - CycloneFilter
Servicing the filter
1. Turn the pressure SmartValve to an unused function or to tank
cleaning nozzles.
2. Unscrew the filter lid (A).
3. Lift lid and filter (B) from the housing.
4. Turn the two locks (C) outwards to unlock the filter from the lid.
5. Separate filter from the integrated filter guide in the lid and clean
the filter.
To reassemble
1. Grease the two O-rings on the lid/filter guide. Due to small space
at lid, use for example a brush to apply the grease.
2. Mount the filter onto the recess (which may not be greased) in the
lid/filter guide.
3. Turn the two locks (C) inwards to lock the filter to the lid.
4. Place the filter/filter lid into the housing and tighten the lid until it hits the stop.
±
WARNING! Always wear protective clothing and gloves, before servicing the filter!
€
DANGER! Never open the Cyclone filter unless the pressure SmartValve and suction SmartValve are both closed
(turned to an unused position)! If no unused pressure positions are available, then turn the pressure SmartValve to
“Tank Rinse”. Otherwise, spraying liquid may hit you when opening the filter, and drain the main tank contents!
10 Hours Service - In-Line filter (optional equipment)
If the boom is equipped with In-Line Filters, unscrew the filter bowl to
inspect and clean the filter. When reassembling, the O-ring should be
greased.
Alternative filter meshes are available. See section on Technical
specifications - Filters and nozzles.
±
WARNING! Be careful not to splash out liquid when unscrewing
the filter bowl.
±
WARNING! Always wear protective clothing and gloves before
opening the filter!
10 Hours Service - Nozzle filters
Check and clean.
10 Hours Service - Spraying circuit
Fill with clean water, operate all functions and check for leaks using higher spray pressure than normal. Check nozzle spray
patterns visually using clean water.