Hardi Mercury Series, Инструкция

Страница: 43 / 114

3 - Description
43
Filters
The suction filter captures impurities in the fluid from reaching the pump. It is located on the left side of the front of the
mistblower, beside the pump.
The pressure filters are assembled on the back of the chassis, just behind the blower unit. These filters are assembled as
standard on all models.
It is essential that all filters perform their function correctly, so they should be checked regularly. Pay special attention to the
filter/mesh size combination.
Suction filter
This filter is assembled under the 3-way valve belonging to the suction
circuit.
The standard filtering element is white and has a mesh size of 30
(0.58 mm). For more information on the mesh size, see the section on
‘Technical specifications’.
Pressure filters
The pressure filters are located in the bumper, beside the air discharge
nozzle. In the HLC circuit, the filters are manufactured from synthetic
material.
These filters must be in perfect conditions and cleaned regularly. Pay
special attention to the correct filter/mesh size combination. The mesh
size must always be smaller that the average of the nozzle total flow.
Powder mixer
This is used to rinse the filter basket intank’s filling hole when adding
powdered products that do not dissolve properly form lumps on
contact with the water in the tank.
After using the powder mixer it must be disengaged as it uses a large
amount of the available pump capacity.