Hardi Mercury Series, Инструкция

Страница: 51 / 114

4 - Sprayer setup
51
Lock device on turnable drawbar
The turnable drawbars are fitted with a lock device, once down in
forward and horizontal position; the pivoting effect is very limited. If
the tractor has a weight 2 X the sprayer, it can be used in hilly
conditions, where risk of tumbling the sprayer exists, but it is
recommended to use the drawbar unlocked.
Adjusting the track width (only available on some model)
To adapt the track width to the terrain, a simple adjustment of the semi-
axles needs to be performed.
Proceed as follows to correctly adjust the width:
1.
Raise the machine at the back so the wheels do not touch the
ground.
2.
Loosen the two nuts and bolts (B) that fasten the axle inside the
housing.
3.
Push the axle inwards or outwards, depending on whether greater
or less track width is required.
4.
When the axle is in the correct position, tighten the bolts (A) and
the locknuts (B) again.
5.
Repeat this operation with the other axle.
€
DANGER! Do not remove the axle from the housing more than that allowed. The correct position for the axle is when
the axle is properly fastened with the two bolts (b) in the housing.
Adjusting the axle position (Wheel base)
Depending the air kit fitted to the equipment and the adjustment made
to the chosen drawbar, the position of the axle may need to be adjusted
to improve the machine’s stability.
€
DANGER! Risk of personal injury. Before working underneath the
machine make sure it is lifted and supported properly! Never rely
on a hydraulic jack only.
Proceed as follows to correctly adjust the width:
1.
Raise the machine at the back so the wheels do not touch the
ground.
2.
Remove the semi-axles.
3.
Loosen and remove the two bolts (A) that fasten the axle housing
on both sides of the frame.
4.
The housing needs to fitted further back if the machine jumps at the front when empty.
5.
Tighten the bolts (A) again when the housing is in the desired position.
6.
Re-fit the semi-axles.
μ
ATTENTION! Always retighten all bolts again after a few hours work.