Hardi Mercury Series, Инструкция

Страница: 20 / 114

2 - General Safety Instructions
20
Design Changes
Operator Limitations
You may make no changes, expansions or modifications to the sprayer without an authorization from HARDI. This also
applies when welding support parts.
Any expansion or modification work shall require the written approval from HARDI. Only use modification and accessory
parts approved by HARDI, so that the type approval or other design approvals remain valid in accordance with national and
international regulations.
Vehicles with an official type approval, or with equipment connected to a vehicle with a valid type approval, or approval for
road transport according to the local road traffic regulations, must be in the state specified by the approval.
It is strictly forbidden to
•
drill holes in the steel frame or in the running gear
•
increase the size of existing holes in the steel frame or in the running gear
•
weld support parts.
Risk of crushing, cutting, catching, squeezing, getting trapped, being drawn in or being struck by sprayer parts due to the
failure of support parts.
Spare Parts, Wear Parts and Aids
Immediately replace any sprayer parts which are not in a perfect state.
Only use genuine HARDI spare and wear parts or those approved by HARDI, so that the type approval remains valid
according to the national and international regulations. The use of spare and wear parts from third parties does not
guarantee that they have been constructed in a way as to meet the requirements placed on them.
HARDI accept no liability for damage caused by the use of non-approved spare parts, wear parts or aids.