Harbor Freight Tools Central Machinery Industrial 95302, Инструкция по сборке и эксплуатации

Страница: 17 / 32

Page 17 SKU 95302
for technical questions, please call 1-800-444-3353.
Basic Bandsaw Operation -- Vertical Position:
WArNING! Always wear ANSI approved safety impact eye goggles when operat-
ing the Bandsaw.
WArNING! When operating the machine, keep the Bandsaw Blade enclosure
closed.
Do not plug the Power Cable (500) into an electrical outlet until all necessary
adjustments (as previously discussed in this manual) have been made.
COOLANT PUMP
fITTING
(91S)
COOLANT PUMP
TOGGLE SWITCH
(750-5)
CyLINDEr
(216)
POWEr CABLE
(500)
MOTOr
TOGGLE
SWITCH
(750-5)
SAW BLADE
(251)
LArGE VErTICAL CUTTING PLATE (867)
SAW HEAD ASSEMBLy
fIGUrE P
Raise the Saw Head to its full vertical position, making sure it locks in place by
turning the Cylinder (216) to its
“Off” position. (See figure P.)
Once all necessary adjustments to the Bandsaw have been made, plug the Power
Cable (500) into the nearest
115 volt, grounded, electrical outlet.
Turn the Coolant Pump Fitting (91S) to its “OPEN” position. Then, turn the Coolant
Pump Toggle Switch (750-5) to its
“ON” position. (See figure P.)
Turn the Motor Toggle Switch (750-5) to its
“ON” position. (See figure P.)
CAUTION! Cut only flat work pieces when the Bandsaw is in its vertical position.
Never attempt to cut pipes or other round objects with the Bandsaw in its vertical
position.
Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade
(251) tension or machine vibration. If this is found, turn off the Bandsaw and correct
the problem before using.
(See figure P.)
Set the workpiece on the Large Vertical Cutting Plate (867), making sure to keep
downward pressure on the workpiece throughout the cutting process.
(See figure P.)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.