Harbor Freight Tools Central Machinery Industrial 95302, Инструкция по сборке и эксплуатации

Страница: 15 / 32

Page 15 SKU 95302
for technical questions, please call 1-800-444-3353.
Adjusting The Blade Tracking:
Raise the Saw Head to its full vertical position, making sure it locks in position by
turning the Cylinder (216) to its
“Off” position. (See figure j.)
ADjUSTING
HEx HEAD
SCrEW
(240)
HEx HEAD
SCrEW
(243)
IDLEr
WHEEL
(250-1)
ADjUSTABLE
BLADE KNOB
(245)
fIGUrE M
Turn on the Bandsaw. The Saw Blade (251) is tracking properly when the back of
the Blade is just touching the edge of the Idler Wheel (250-1) flange. The back of
the Blade should not be rubbing against the flange.
(See figure M.)
If adjustment is necessary, the Blade Guide Bearings (266-10) should be clear of
the Saw Blade (251).
(See figure M.)
Loosen the upper Hex Head Screw (243) to a point where it is just barely snug.
(See figure M.)
With the Bandsaw running, turn the Adjusting Hex Head Screw (240) until the Saw
Blade (251) is tracking properly, making sure Blade tension is maintained by turning
the Adjustable Blade Knob (245).
(See figure M.)
Make sure to retighten the upper Hex Head Screw (243) when adjustment is com-
plete.
(See figure M.)
Adjusting The Blade Tension:
Turn the Adjustable Blade Knob (245) clockwise to increase tension on the Saw
Blade (251). Turn the Adjustable Blade Knob counterclockwise to decrease tension
on the Saw Blade. Correct tension is acquired when the Saw Blade is just tight
enough so that no slippage occurs between the Saw Blade and the Wheels (231S,
250-1).
(See figure M.)
NOTE: When the Bandsaw is not in use over long periods of time, release the ten-
sion on the Saw Blade (251).
1.
2.
3.
4.
5.
6.
1.
2.