Harbor Freight Tools Central Machinery Industrial 95302, Инструкция по сборке и эксплуатации

Страница: 12 / 32

Page 12 SKU 95302
for technical questions, please call 1-800-444-3353.
SPEED INDICATOr DIAL
(800-7)
fIGUrE f
To change the blade speed according to the material being cut, turn the Speed
Indicator Dial (800-7) to the necessary speed. IMPOrTANT: Do not attempt to
change the speed while the Bandsaw is running. Always make sure the Bandsaw
is at a complete stop prior to changing speeds.
(See figure f.)
To Use The Quick Vise:
fIGUrE G
frONT VISE jAW (9)
KNOB
(600)
SHAfT
(609)
The Bandsaw is equipped with a “quick action” Vise which allows you to instantly
position the moveable Front Vise Jaw (9). To operate, turn the Shaft (609) to its
vertical position. Turn the Knob (600) clockwise or counterclockwise and move
the Front Vise Jaw to the desired position. Then tighten the Front Vise against the
workpiece by turning the Shaft to its
horizontal position. (See figure G.)
To Use The Quick Vise Adjustment for An Angle Cut:
frONT VISE jAW
(9)
SCALE
(13)
SWIVEL
BASE
(1)
THrEADED HOLE
SCrEW
(20)
SCrEW (21)
rEAr VISE jAW (22)
SCrEW (21)
fIGUrE H
Loosen the four Screws (20, 21). Adjust the Rear Vise Jaw (22) to the threaded
hole position. Set the Scale (13) to the desired angle. Adjust the Front Vise Jaw
(9) to parallel the Rear Vise jaw. Then, re-tighten the four Screws.
(See figure H.)
2.