Harbor Freight Tools Central Machinery Industrial 95302, Инструкция по сборке и эксплуатации

Страница: 21 / 32

Page 21 SKU 95302
for technical questions, please call 1-800-444-3353.
INSPECTION, MAINTENANCE, AND CLEANING
WArNING! Make sure the Motor Toggle Switch (750-5) and Coolant Toggle Switch
(750-5) of the Bandsaw are in their
“Off” positions and the tool is unplugged from
its electrical outlet before performing any inspection, maintenance, or cleaning
procedures.
Before each use, inspect the general condition of the Bandsaw. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect its safe operation.
If abnormal noise or vibration occurs, have the problem corrected before further
use.
Do not use damaged equipment.
Before each use, inspect the Saw Blade (251). Using a dull Saw Blade will cause
excessive wear on the Motor of the Bandsaw and will not produce a satisfactory cut.
Replace with a new Saw Blade when needed. To replace a Saw Blade:
NOTE: Make sure to wear heavy duty work gloves to avoid accidental cuts from
the Saw Blade (251) when performing this procedure.
fIGUrE r
IDLEr WHEEL
(250S)
DrIVE WHEEL
(231S)
SAW
BLADE
(251)
BLADE BACK COVEr
(286S)
UPPEr
GUIDE
ASSy.
LOWEr
GUIDE
ASSy.
ADjUSTABLE BLADE KNOB (261)
Turn the Cylinder (216) to its
“ON” position, and raise the Saw Head to its full
vertical position. Then, turn the Cylinder to its “Off” position to lock the Saw
Head in place.
(See figure r.)
Open the Blade Back Cover (286S). (See figure r.)
1.
2.
3.
a.
b.
c.