HappyJapan HCS3, Инструкция

Страница: 13 / 364

-S3 -11 2_4 U701
2-4c
SETTING UP THE MACHINE
1. Attach the studs (2 pieces) to the rear side
of the table with the provided screws (M6x16).
Attach the table stay A to the front side of
the table with the provided screw (M6x16),
attach the table stay B with the Wing bolt,
and install the table stay A with the adjuster
with the Wing bolt.
2. Place the table with studs and table stay
upside down in front of the embroidery ma-
chine.
At this time, loosen and adjust the wing bolt
so that the height of the adjuster is about
the same as the bottom surface of the nee-
dle plate.
Assemble table stay and table (Option)
Installing the table using the table stay.
When fi xing the table, use the table stays to place the front of the table on the fl oor.
When using the border frame, it is necessary to set the table in advance.
Table stay A
Wing bolt
Table stay B
Adjuster
Wing bolt
Stud
Table stay A
Adjuster
Needle plate