Happy HCS-1201-30, Руководство по обслуживанию

Страница: 66 / 204

66/204
Check of needle position
3-3-5
1. A main part is turned on.
The ENT key is pressed and it changes into an operation
state.
2. Press a Needle change button and make it the 6th needles.
3. Stick a seal on needle hole of a needle plate.
4. P.FOOT A key is pressed and cloth control is lowered.
5. Lower a needle bar with a finger.
6. Turn an upper axis up to [302 degrees - 303 "], and it is the
needle mark to a seal. A hole is made.
<Note>
Needle point will become large if the angle of a dial disc
is made into 304 degrees or more.
An exact needle position check becomes impossible.
7. Reverse-rotate an upper axis, raise a needle bar, and
unite with C [275 degrees].
(It returns to 303 degrees-> 220", and unites with 275
degrees after that.)
<Note>
If a top axis is right-rotated, a needle will enter deeply,
and needle hole is greatly.
It becomes. Therefore, an exact needle position check
becomes impossible.
8. 1st needle and the 12th needles are to 302 degrees - 303
degrees about an upper axis by the above-mentioned
procedure. It turns, a needle is lowered and a needle
position is checked.
It will be O.K. if the needle point goes into the seal hole
made by the 6th needles at this time.
* If “NG”. Please adjust again, follow to [3-3-3 Asemble
the moving head] of procedure 6-10.
The order which the screw which is fixing the move head
fastens -- from an inner side. If it does not carry out
correctly outside, a needle position will shift -- it is –
9. Un-stick a seal on needle plate to finish.