Happy HCS-1201-30, Руководство по обслуживанию

Страница: 201 / 204

201/204
Error and measure
7-3-1
No. message Error measure page
111 Change over While reading pattern data, the (1)
Modify pattern data and reduce frequency of color
frequency of color change (color No.)
change of one pattern to less than 250 times.
exceeded 250 times. (2)
Divide pattern data and reduce frequency of color
change of one pattern to less than 250 times.
112 Data error Pattern data of pattern to be (1)Read pattern data again from the first. (5-8)
embroidered is damaged. (2)Read pattern data again if you have
a backup data.
114 Id over The number of pattern in memory has Delete unnecessary patterns and read. (5-8)
reached maximum of 99.
118 Trace data over The stitch number counts over 1024 Set Embroidery area of pattern data within
stitches during preparing Trace data. 2m(X) x 2m(Y).
120 Memory error It became impossible to retain contents (1)Replace the battery for memory backup. 4-1-2
of memory. (2)Replace the CPU circuit board if recurs even
change the battery.
130 Card error Incapable of disposing of memory card (1)
Turn off power source once and turn it on again.
continuously. (2)
Memory card reading processor may defective.
Replace the circuit board.
131 Card no ready Memory card is not set. Check if memory card is properly set. (5-5)
133 Bad card Memory card is not proper or broken. (1)
Memory card might be not readable with the machine.
(5-5)
Prepare readable memory card for the machine.
(2)
Memory card might be defective.
Prepare another memory card which is not defective.
(3)Initialize the memory card if it is not initialized.
141 Not found name Designated pattern is not found.
Memory card might be not readable with the machine.
(5-5)
Prepare readable memory card for the machine.
190 Cut blade Thread cut knife is not at stop position. (1)Restore the moving knife to stop position. (10-7)
(2)Modify the adjustment if the problem repeats.
193 Catcher Thread catch hook is not in its (1)Check if mistake is found in thread cut. (10-8)
stop position. If found, cut thread and move thread catch
hook to proper position
.
(2)Adjust and correct trouble that hinders motion
of thread catch hook.
( ) ----- Reference instruction book