Happy HCS-1201-30, Руководство по обслуживанию

Страница: 191 / 204

191/204
Trouble shooting(Malfunction of thread break detection)
7-2-7
Trouble Factor Cause of trouble and measure Page
Malfunction
of Mechanical
1. Trouble in turning detection roller.
thread break 1-1 Clean roller shaft holder.
detection 1-2 Check if slit disc doesn't contacts sensor. 4-2-2
(empty 1-3 Clean sensor if dust gets stuck.
detection) 1-4 Check if cord doesn't contacts slit disc.
1-5 Check Disconnection of cable.
2. Check circuit board.
2-1 Replace of CPU board.
2-2 Replace of TC 12 board.
3. Sometimes needle bar doesn’t work when start sewing.
3-1 Replace if cushion has been decrepit.
3-2 Replace of needle bar driver.
3-3 Adjust of jump solenoid position.
3-4 Clean and overhaul of Jump solenoid.
3-5 Replace of Jump solenoid.
Operator 1. No thread is passed through detecting roller.
1-1 Pass thread properly. (4-6) (4-7)
2. Is thread tension proper?
2-1 Observing sewing rhythm, adjust thread tension properly. (4-5) (8-1)
3. Is proper detection sensitivity of thread cut selected?
3-1
Select detection sensitivity according to sewing condition of thread and cloth etc.
(11-3)
Environment
1. Is there any device to yield lints etc. around the embroidery.
1-1 Keep it off the embroidery machine.
1-2 Move the embroidery machine to other place.
2.
Doesn't thread go beyond control by wind? (thread comes off from needle hole by loosing)
(2-5)
2-1 Keep thread off wind.
2-2 Move the embroidery machine to other place.
Thread & 1. Isn't silicone agent used on thread?
Cloth (Thread slips at detecting roller part due to adhere of silicone.)
1-1 Clean silicone agent attached to detecting roller groove.
( ) ----- Reference instruction book