Happy HCS-1201-30, Руководство по обслуживанию

Страница: 188 / 204

188/204
Trouble shooting(Upper thread comes off from needle hole)
7-2-5
Trouble Factor Cause of trouble and measure Page
Upper thread
Mechanical
1. Is keeper in motion?
comes off 1-1 Check if cable was cut or there is something unusual.
from needle 1-2 In case solenoid is in trouble, replace.
hole 1-3 In case CPU board is in trouble, replace.
2. Is keeper put in right place?
2-1 Put it as specified. 3-6-9
2-2 Modify bent of keeper.
2-3 Adjust it again if movement is not smooth.
3. Is magic-tape on thread catch holder not worn?
3-1 Replace magic-tape.
4. Does bobbin thread holder hold bobbin thread?
4-1 Adjust pressure when contacting moving knife. 3-6-8
4-2 In case bobbin thread holder is in trouble, replace.
4-3 Clean bobbin thread holder.
5. No error in thread cut (2 threads cut)?
5-1 Check and adjust thread cut timing. 3-6-3
5-2 Position moving knife as specified. 3-6-7
5-3 Check and polish burr or scratch on moving knife.
5-4 In case moving knife is in trouble, replace. 3-6-4
6. Are clearance between needle and rotary point and needle height are proper?
6-1 Adjust clearance between needle and rotary hook as specified. 3-5-1
6-2 Adjust needle depth. 3-3-3
7. Doesn't thread catch hook cut upper thread?
7-1 Polish burr on hook.
7-2 In case hook is in trouble, replace.
8. Does thread catch hook hold upper thread?
8-1 Check if cable was cut or there is something unusual.
8-2 In case pulse motor is in trouble, replace.
8-3 Adjust fixing position. 3-2-13
8-4 If hook is bent, modify.
8-5 In case hook is in trouble, replace.
8-6 In case CPU board is in trouble, replace.
9. Check tension of thread adjusting spring is too weak.
9-1 Adjust of tension. 3-3-8
10. Check Stroke of thread adjusting spring is too big.
10-1 Adjust of stroke. 3-3-9
( ) ----- Reference instruction book