Happy HCS-1201-30, Руководство по обслуживанию

Страница: 200 / 204

200/204
Error and measure
7-3-1
No. message Error measure page
030 Slow mismatch Inadequate adjustment of number of (1)Make automatic speed setting. 5-3-1
low speed revolution. (2)If not solved even after speed adjustment, (11-1)(11-2)
Low speed revolution doesn't come replace CPU circuit board.
below 100rpm.
050 C point Main shaft stops off its position. (1)
Turn main shaft to plus direction to set to C point.
(10-6)
(2)Adjust brake device.
051 L sensor Poor lowest needle position sensor (1)If photo sensor is stained, clean. 4-2-1
on timing detecting circuit board. (2)Adjust timing. (11-1)(11-2)
Damage in timing detecting circuit (3)Replace main shaft timing circuit board.
board, stained photo sensor, poor
adjustment of slit disc.
052 C sensor Damage in color change point
sensor on timing circuit board.
Damage in timing detecting circuit
board, stained photo sensor, poor
adjustment of slit disc.
055 Take-up cover Take-up cover is open. (1)Please close take-up cover.
Limit switch of take-up cover is defective
. (2)Replace the limit switch if defective.
060 X limit
Drive frame went beyond limits in X direction.
(1)Move drive frame back to limits with move key.
061 Y limit
Drive frame went beyond limits in Y direction.
(2)Correct pattern size and setting contents.
090 Miss reception Error occurred when transmitting data. (1)Let the machine read pattern data from first. (5-4)(5-6)
(2)Set transmitting speed of the machine and
personal computer.
091 No send Data is not put in for over 10 seconds. Let the machine read data from first. (5-4)(5-6)
103 Data format The machine can’t judge format of (1)Check format of pattern data. (5-2)
pattern data. (2)By setting reading of pattern data,
set format properly.
104 Miss function Timing to read pattern data doesn't Read pattern data again from the first. (5-4)(5-6)
conform.
105 Dual function One stitch data has more than 2 (1)Read pattern data again from the first. (5-4)(5-6)
functions. (2)
Check and modify the design data if there is wrong.
108 Improper read While reading pattern data, there Read pattern data again from the first. (5-4)(5-6)
accrued error in internal processing.
110 Memory full While reading pattern data, memory Delete unnecessary patterns and read from (10-1)
exceeded its capacity. the outset.
( ) ----- Reference instruction book