Track mode
Table 2-34 Track mode function menu:
Option
Setting
Introduction
Cursor Mode
Track
In this mode, set track cursor measure.
Cursor A
CH1
CH2
NONE
Set the input signal channel that the
Cursor A will measure.
Cursor B
CH1
CH2
NONE
Set the input signal channel that the
Cursor B will measure.
Cur A
Select this option, turn the Universal knob to
adjust horizontal coordinate of Cursor A.
Cur B
Select this option, turn the Universal knob to
adjust horizontal coordinate of Cursor B.
In this mode, the screen displays two cross cursors. The cross cursor sets the
position on the waveform automatically. You could adjust cursor's horizontal position
on the waveform by turning the Universal knob. The oscilloscope displays the
values on the top of the right screen.
To do track cursor measurement, follow these steps:
●
Press
CURSOR button to enter the cursor measure function menu.
●
Press
the Cursor Mode option button to select Track.
●
Press
the Cursor A option button to select the input signal channel.
●
Press
the Cursor B option button to select the input signal channel.
●
Select
Cur A, turn the Universal knob to move Cursor A horizontally.
●
Select
Cur B, turn the Universal knob to move Cursor B horizontally.
●
The
measurement values are displayed on the left of the top corner:
A→T: The horizontal position of Cursor A
(Time cursor centered around the midpoint of screen).
A→V: The Vertical position of Cursor A
(Voltage cursor centered around channel ground level).
B→T: The horizontal position of Cursor B
(Time cursor centered around the midpoint of screen).
B→V: The Vertical position of Cursor B
(Voltage cursor centered around channel ground level).
△T: Horizontal space between Cursor A and Cursor B
(Time value between two cursors).
1/△T: The reciprocal of horizontal space between cursor A and cursor B.
△V: Vertical space between Cursor A and Cursor B
(Voltage value between two cursors).
Auto mode
Table 2-35 Auto mode function menu:
Cursor Mode
Auto
Set to auto cursor measure mode.
Option
Setting
Introduction
This mode will take effect with automatic measurements. The instruments will
display cursors while measuring parameters automatically. These cursors
demonstrate the physical meanings of these measurements.
To do auto cursor measurements, follow these steps:
●
Press
the CURSOR button to enter Cursor measure menu.
●
Press
the Cursor Mode option button to select Auto.
●
Press
the MEASURE button to enter Auto cursor measure mode menu to
select the parameter that you want to measure.
62
Digital
S
torage
O
scilloscope
Digital Storage Oscilloscope
63
