Hanseatic WQP12-T7735E, Руководство пользователя

Страница: 70 / 80

Page EN-28 Installation, connection and commissioning
a) If you have granite worktops, re-
move the internal side cover caps (e)
and screw the dishwasher to the ad-
jacent kitchen cupboards.
Re-cover the screws (j) with the cover
caps.
b) For all other worktops, screw the
mounting bracket (f) to the work sur-
face until it is fixed.
Mounting the front panel
A front panel must only be used for the model
with the article number 823 724.
You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(g)
3. A gap of 5 mm to 25 mm can be offset
with the 5 mouldings supplied (g). Re-
move the required number of moulding
from the block. To do so, move the mould-
ing vigorously but without using tools.
4. If you only need one moulding, saw
off the four feet that stick out,
clamp the moulding under
the control panel and secure
it using both countersunk
screws (l).
Continue with Step 7.
5. If you need more than one moulding, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
6. If you
– need two mouldings, secure these using
both countersunk screws (l).
– need three mouldings, secure these us-
ing both countersunk screws (m).
– need four to five mouldings, secure these
using both countersunk screws (n).
(h)
7. Pull the two pairs of Velcro straps (h)
apart.
8. Remove the protective film from the same
type of Velcro strap.
(h)
(h)
9. With the protective film removed, affix
the Velcro straps to the middle of the re-
cessed areas on the dishwasher door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of trim strips used off the
drilling template.