86
–
When operating forklift attachments with multiple functions, such as with side-shifter, clamp or
rotator, it is forbidden to perform two actions at the same time, and only after one action is
completed, another action can be performed.
–
Forklifts equipped with attachments are strictly prohibited from driving in a high cargo position;
when the volume of the cargo is too large, it is forbidden to drive the forklift forward; when
transporting cargo, ensure that the bottom of the cargo is 300mm off the ground and the mast
is tilted backwards.
–
The weight of the goods cannot exceed the limit of the combined carrying capacity of the forklift
and attachments. Try not to eccentrically load at high cargo positions. For attachments with
sideshift function, it can only be operated in a short time. The eccentric load is strictly controlled
at 100mm on the left and right (the sideshift amount of the sideshifter above 5 tons (including
5 tons)) within the range of ±150mm).
–
Except fo
r the driver’s position protected by the overhead guard, it is strictly forbidden to stand
within 2 meters of the projection area directly below the attachment and the cargo to prevent
accidents.
–
It is not allowed that an emergency brake in moving. Run slowly with load.
–
It is forbidden to be impacted by external force when the attachment is working; it is forbidden
to use the attachment for improper occasions, and it must not exceed the normal working range
of the attachment.
–
It is forbidden to use the attachment for improper occasions, and it shall not exceed the normal
working range of the attachment.
–
When the attachment fails, it is prohibited to use it without exclusion.
7.3 Attachment check and maintenance
–
Check the clearance between the lower beam of the forklift fork frame and the lower hook of
the attachment, which meets the requirements of the attachment manual.
–
Check that the upper hook is properly seated in the groove of the forklift carriage.
–
Lubricate the upper and lower sliding bearing surfaces with automotive lithium grease every
500 hours.
–
Whether the fasteners are loose.
–
Regularly check whether the joints of the hydraulic circuit of the attachment are loose and
whether the hose is damaged. If there is any damage, do not use it until it is repaired.
–
Regularly check whether each transmission or rotating element of the attachment is worn or
stuck, and if damaged or defective, it needs to be replaced in time.
–
In the case of dynamic load, check whether the working components of the attachment are
normal, whether the working pressure of the attachment is normal, and whether the attachment
is working normally. If it is not normal, you need to check the hydraulic circuit, find out the
leaking components, and replace the seals or the entire loop element.
