84
pallet, move forward slowly, insert the fork
into the pallet as much as possible and
stop.
Caution
When it is difficult to insert the forks fully
into the pallet, drive forward so that the
forks are inserted to 3/4 of their length.
Raise the forks by 5
–10cm, back up 10–
20cm, then lower the pallet or rack. Drive
forward again until the forks are fully
inserted.
─
Raise the forks 5
–10cm off the stack.
─
Look around the vehicle to confirm that
there is no obstacle, and then back up
slowly.
─
The fork should drop 15cm~20cm from the
ground, the mast should be tilted back in
place, and then transported to the
destination.
Check before parking
−
Stop the vehicle
−
Fully lower the mast
−
Set the direction switch to zero or neutral
−
Apply the handbrake
−
Turn off the power with the key switch,
press the emergency stop switch to cut off
the power.
−
If the vehicle must be parked on a slope,
chock the wheels with chocks.
Check after operation
After use, clean the forklift and carry out the
following checks
:
−
Check for damage and oil leaks.
−
Add lubricant if required.
−
Check tires for damage and foreign bodies
embedded in the treads.
−
Check for loose hub nuts.
−
Check the electrolyte level.
−
If the forks have not been elevated to their
maximum height during the day, after
finishing work, raise them to their
maximum height 2 to 3 times.
Caution
⚫
If any fault is found, it should be
repaired in time.
⚫
Do not use the forklift until it has
been
fully repaired.