Handicare AP-450, Руководство пользователя

Страница: 6 / 55

6
unplugging the charger.
Low Battery
If the batteries of the lift are low (25%) and require charging, the indicator located on the top cover
membrane of the lift lights orange, a beep audible alarm sounds when button is pressed, and the
Hand Control displays the message
Low Battery . If a transfer is in progress, complete the
transfer (the Emergency Down also continues to operate) and move the lift to a location where it
can be charged.

The lift may be used after one hour of charging from low battery; however, Handicare
recommends overnight charging or minimum of 5 hours.
If the batteries are fully discharged and require charging, the indicator on the lift control panel
lights red a beep audible alarm sounds when button is pressed, and the Hand Control displays
the message
Very low battery .
When the battery is discharged the UP function is disabled. The Down, and
Emergency Down continue to operate.
Power supply is considered a part of the AP-450 system. Use only the
charger that was supplied with the lift. Use of any other charger will void all
warranties and may cause damage to the lift.
Do not position the lift where it is difficult to disconnect the charger in an
emergency.
The u
nit can be isolated electrically from “Mains” by unplugging the charger.
Plug Types
Plug types vary by geographical location. Refer to local electrical guidelines on the type of plug or
voltage which can be used (connection to the charger is an IEC 60320-C7 plug).
Attach the Hand Control to the Lift
A sturdy ladder may be required to access the hand control connection to
re-attach the Hand Control to the lift. Use caution whenever using a ladder.

Should you have any concerns or questions contact your local Handicare dealer or your local
Handicare business development manager.

Should the Hand Control disconnect from the side of the lift it must be re-connected in order
for the hand control to work. The lift can still be lifted and lowered using the membrane
located on the top cover while the hand control is disconnected.
The Hand Control of the AP-450 is designed with a locking connector to withstand normal
day-to-day usage. However, the connector can become disconnected if:

The lift is pulled along the track by the Hand Control cord

The Hand Control cord gets wrapped around an object while a lift or transfer is being
performed

Hand Control cord is accidentally pulled down by the caregiver or the individual being lifted
The Hand Control is connected to a lift connector located on the side of the lift.
The small latch arm on the Hand Control connector holds the Hand Control cord to the lift
connector in a specific orientation.
Connect the Hand Control
Both the male connector on the cord and the female connector have a latch.
Make sure that the male connector is inserted into the lift connector in the proper
orientation.
1. Line up the latch and latch opening as shown in Figure 3.
2. The latch has to be aligned with the cavity of the connector.
3. Insert the cord connector completely into the connector on underside of the lift until you hear
a click.
4. Pull lightly on the connector to confirm proper connection.