38
|
Hampton®H15E-11DirectVentFreestandingGasStove
installation
CONVERSION FROM NG TO LP
H15E-11
920-031
06.17.20
CONVERSION FROM NG TO LP
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG
Conversion Kit (Part#382-977)
LP Conversion Kit Contains:
Qty. Part #
Description
1
904-529
5/32" Allen Key
1
Burner Orifice #55
1
918-590
Label "Converted to
LPG"
1
908-528
Red "LPG" label
1
910-037
LP Injector (Pilot Orifice)
1
911-011
Stepper Motor
1
920-031
Instruction Sheet
Remove the 2 screws, push Burner
Assembly to the left and lift out.
Burner Orifice
Installation of LP Conversion Kit:
1. Shut off the gas and electrical supply.
2.
Lift off the Cast Top and remove the cast front
and the glass door (see details in manual).
3. Remove the logs, embers (if installed).
4. Remove the 2 screws holding the Burner
Assembly to the firebox base. Push the
Burner Assembly to the left and lift out.
6.
Unscrew the pilot orifice with the allen key
and replace with the LP pilot orifice in the
kit and replace pilot cap.
7.
Remove burner orifice with a 1/2" wrench
and discard. Use another wrench to hold
on to the elbow behind the orifice.
8.
Reinstall new burner orifice LP stamped #55
and tighten.
9. Open the front panel and remove the cover
plate by removing two screws.
10.
Remove the right side access panel by removing
1 screw and disconnect the NG stepper mo-
tor wires from the IFC marked X6 in location
shown below.
Installer Notice:
These instructions must remain
with the appliance.
11. Remove NG stepper motor by removing 2
screws in locations shown below. Replace
with LP stepper motor, secure in place
with 2 screws.
12.
Connect the LP stepper motor to the IFC
(same port as NG stepper removed from
in Step 10), reinstall access panel.
13. Attach the label “This unit has been
converted to LPG” near or on top of the
serial # decal.
14. Replace yellow “NG” label with red “LPG”
label.
15. Reverse steps 4 through 1.
16.
Check for gas leaks.
17. Check inlet and outlet pressures.
18. Check operation of flame control.
5. Pull off the pilot cap to expose the pilot
orifice.
