HAMAR LASER L-703SP, Руководство пользователя

Страница: 10 / 57

6
T-1297 Angular Mode - Optional
To use the T-1297 Targets in Angular Mode, the T-1295-AO-3 Lens or the A-1295-
AO-6 Lens need to be purchased. To use them, insert the lens into the target face
making sure line up the red or yellow dots at 12:00 when you insert it (see Figure 7 ).
Note: To use this in angular mode, this will require the purchase of the T-1295-AO-3/6
Angular Lens and Lathe10 or MultiTurn10 Software. Plane6 does not support Angular
Mode
Then click on the Angle button in Step 2 or 5 (see below) and the values will switch
to the angular display. Using the lens, converts the display readings in Lathe10 or
MultiTurn10 to angular values with the following raw-value resolution:
T-1295-AO-3: in/3 in. (mm/76.2 mm), which is converted in the software displays to:
in/ft or mm/m when you click on the Angle Button (see figure below).
T-1295-AO-6 : in/ 6 in. (mm/152.4 mm), which is converted in the software displays to: in/ft (mm/m) when you click on
the Angle Button.
Note if the displays are left in Center Mode, then the values shown in the displays are
raw
values and will be in the units
shown above.
T-1297 Scanning Laser Mode - Optional
The T-1297 Targets can be converted to scanning targets to be used with the
L-702SP laser in
Scanning Mode
(or any L-730/L-740 Series lasers), which creates a
laser plane.
To change, the T-1297 target into Scanning Mode, make sure the L-702SP is
turned off
or the laser beam is blocked. Then press and hold the Power Button ( see Figure 9 ). The
ON-TGT LED will blink instead of being continuously on, as it is when it’s in 2-Axis
Center Mode . To return the T-1297 to 2-Axis Center Mode power down the target and turn it back on.
Note : You must also put MultiTurn10 into Scan Mode using the dropdown list in Step 3.
Figure 8 - MultiTurn10 Step 5 – showing Angle Mode turned on
Figure 7 - T-1295/T-1296 Target with T-
1295-AO-3 Lens installed correctly
Figure 9 - T-1295/1296 Control Panel
Figure
10
- Target Scan Mode Selection
Step 3