12
Screen Power save
■
Power save/Auto shut-off
To reduce the battery power consumption, the device may enter into the state of power save/auto
shut-off after elapse a certain period of time. In the power save state, while the contents being edited in
the Setting mode are retained, they will be lost once the device is shut down.
・
In case of the measurement mode
If there is no temperature input exceeding 100°C (212°F) for a period of 3 minutes or over, or no
operation of button, the device will be powered OFF. You will be notified by the buzzer beeping 30
seconds before the powering OFF.
・
In case of other than the measurement mode
If there is no input, ID reading, button operation, etc. for a period of 3 minutes or over, the device will
enter into the state of power save.
* In the recording mode, if the device has transitioned to the power save state after temperature
measurement, it will automatically save the data.
If no recovery occurs in 3 minutes after the entry into the power save state, the device
will be powered OFF.
Recovery from the power save mode
Pressing the (SET) button causes the recovery from the power save mode.
NOTE:
With any particular temperature input or button operation, the buzzer will stop beeping and
the countdown will be reset.
P o w e r s a v e
P r e s s S E T b u t t o n
t o a c t i v a t e
●
Overview of modes
This product has the following modes:
Measurement mode
Recording mode
Unit record mode
Fail List mode
Calibration date mode
M'ment number mode
Group ID List mode
Setting mode
- This is a mode of an ordinary thermometer.
- In linkage with the barcode reader, it records temperature data.
- Used to view data for each unit.
- Used to view data that proved a fail through the temperature
range judgment.
- Displays the thermometer calibrated date and scheduled date of calibration.
- Displays the cumulative rounds of measurement.
- Displays IDs registered for each group.
- Used to set a variety of settings of this product.
(Protected by password)