HAI OmniLT, Руководство пользователя

Страница: 10 / 20

Page 10
Required Equipment
•
HAI OmniLT, Omni II, or OmniPro II Controller:
Version 2.6 or later firmware is required.
•
HAI Model 10A17-1 Serial Interface Module:
The PCS Serial PIM will not work with built-in serial ports on the OmniLT controller. It must be used with the Model
10A17-1 Serial Interface Module.
•
UPB Powerline Interface Module – Serial (PIM-S):
Available from PCS and/or its distributors. To work with OmniLT, the PIM must be Version 4.15 or later and it must be the
“Serial” version (not the USB version). The PCS Serial PIM comes with the proper cable for the 10A17-1 Serial Module.
•
UPB Switches, Modules, and/or Keypad Controllers:
Available from PCS and/or its distributors.
•
UPB UPStart Setup Tool Software:
Free download from PCS (www.pcslighting.com). UPB switches, modules, and keypad controllers are configured using the
UPB UPStart program running on a PC while connected to the PIM. Instructions on installing, configuring, and operating
UPB UPStart and PCS UPB devices are available from PCS. This document will give you some general guidelines for
configuring UPB devices with UPB UPStart for optimal communications with the OmniLT controller.
Note: Although the UPB protocol is extremely robust and less susceptible to powerline conditions, for professional installations, HAI
recommends the use of a UPB Phase Coupler.
Control
OmniLT can control up to 16 UPB devices. Each UPB device (switches, modules, and keypad controllers) has its own
Unit ID (1-16).
UPB devices can not share the same House Code with other PLC (Powerline Carrier) devices, such as X-10.
UPB devices can share the same House Code with ALC devices. Any unit number that is not being used for an ALC Switch Module
may be used for a UPB device. ALC Switch Modules and UPB devices can not be assigned to the same unit number.
Controlling UPB Units
Use the control menu when controlling lights and other UPB devices. To enter the control menu, from the top-level display or from
the main menu, press the 1 (CTRL) key on the console keypad. OmniLT will automatically display the first named item in that list.
Use the down arrow key to scroll through the list.
After the unit has been selected, press the ' # ' key. For UPB units, the console will display:
Entry Lights
0=OFF 1=ON 2=DIM 3=BRT
↓
Entry Lights
4=LVL 6=LED 9=TIM #=STA
↑
Press the 0 (OFF) to turn the selected unit off or the 1 (ON) key to turn the selected unit on.