Hafco Metalmaster S829, Инструкция и каталог запасных частей

Страница: 11 / 31

10
8
8
A
A
D
D
J
J
U
U
S
S
T
T
I
I
N
N
G
G
T
T
H
H
E
E
M
M
A
A
C
C
H
H
I
I
N
N
E
E
BEFORE PERFORMING THE FOLLOWING OPERATIONS, THE ELECTRIC POWER SUPPLY AND
THE POWER CABLE MUST BE COMPLETELY DISCONNECTED.
8.1 Disk Head
If excessive axial play is found on the hinge, it will be sufficient to tighten the screws.
Pay attention and avoid making the joint too tight.
8.2 Adjusting the Mitering Lock Lever
The lock lever may require adjustment when the lever is limited by
the machine base and it fail to adequately secure the miter angle
for machine head. If there is insufficient brakeage of the lock
lever:

Loosen screw (A)

Support the bushing (B) so that it does not drop in position.

Pivot the lever (C) to unlock side to allow more range of
motion.

Then tighten the screw (A).
8.3 Changing the Disk
To changed the disk:

Release the mobile guard (A) by removing the hex socket
screw (B).

Rotate the mobile guard (A) back.

Place a block of wood into the vise.

Lower the machine head to rest the cutting disk or saw blade
on the block of wood.

Use a hex wrench to remove the hex socket screw (C),

Rotate the disk in the clockwise direction to loosen it
(because it has a left-handed thread).

Remove the disk or blade (D) and flange (E) from the head
assembly.

Slip off the flange (E) from the disk (D).

Place the flange onto the replacement disk or blade (D).

Continue the replacement of the disk in reverse order of
removal of the disk.

8.4 Cleaning and Accessing the Coolant System

Pull out the drain hose from the filter (A).

Pull out the coolant tank from the coolant platform in the
stand.

Remove the filter (A) from the tank

Pour out the coolant

Wash out the dirt and debris.

Replace the filter (A).

Fill with coolant solution of 1:10 ratio of coolant to water

Replace the coolant tank in reverse order of removal.
C
A
B
A
C
B
D
E
A