Hafco Metalmaster S829, Инструкция и каталог запасных частей

Страница: 15 / 31

14
9
9
T
T
H
H
E
E
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
C
C
Y
Y
C
C
L
L
E
E
Before operating all the main parts of the machine must be set to optimum conditions (see the chapter
on “regulating the machine”)
9.1 Miter Angle

Use the miter lock lever (A) to release the disk head
assembly.

Rotate the disk head assembly to the correct miter angle.

Check the miter angle on the angle indicator (B) below the
vise

Use the miter lock lever (A) to lock in the miter angle.
9.2 Vise Operation
The quick clamp vise lever allows the operator to quickly clamp and unclamp work-pieces of same
width. This allows for efficient use of machine for loading and feeding forward work-pieces.
Use the hand wheel to open and close the vise jaw for work
pieces that vary in width.

Rotate the hand-wheel (A) counter-clockwise to open the
vise.

Rotate the hand-wheel (A) clockwise to close and approach
the vise jaw (C) to the work pieces.
Use the vise lever to quickly clamp and unclamp work pieces of
the same width.

Rotate the vise lever (B) clockwise to clamp the work-piece.

Rotate the vise lever (B) counter-clockwise to unclamp the
work-piece.
The clamping vise set equips with the function to adjust forward
and backward for extending the clamp capacity.
There is a sliding devise between the swing base and the bottom
of the vise. Please refer to the indicator on picture (9.1 D).

Pull out the vise set that the entire vise ti come out and vice
versa.
The clamping vise equips with another function for making the slot
cutting in the head was set in 90 degree.

Take off the set of bar stop of setting cutting measurement.
Use a hex wrench 5mm to loss the M6x10 screw on the long
rod (Q-6.3 pic.-9 ).

Loosen the miter lock lever (9.1 A).

Rotate the entire dick head unit to the right, checking the
angle on the indicator (9.1, B) at the 90 degree of vise.

Upload the material and clamp it securely before cutting.
A
B
C
A
B
D