Hafco Metalmaster S829, Инструкция и каталог запасных частей

Страница: 6 / 31

5
6
6
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
T
T
E
E
D
D

Make sure that the electrical supply and the machine’s voltage are the same. Refer to
the identification plate on the motor for the correct voltage.

Use a good quality grounded electrical system.

All internal and/or internal operations, maintenance or repairs, must be performed in a
well-lit area or where there is sufficient light from extra sources so as to avoid the risk of
even slight accidents.
6.1 Minimum Requirements for Housing the Machine
The Main voltage and frequency complying with the requirements for the machine’s motor.
Environment temperature from –10°C to +50°C.
Relative humidity not over 90%.
6.2 Anchoring the Machine

Position the machine on a firm and level concrete floor.

Maintain a minimum distance of 800mm from the wall to
rear of the machine.

Anchor the machine to the ground, as shown in the
diagram, using screws and expansion plugs or sunken
tie rods that connect through holes in the base of the
stand.

Ensuring that it is sitting level.
6.3 Assembly and Setup
Positioning the machine
Please follow the instruction bellow when unpacking the machine
from the package.

Take out the accessory box from the rear for assembling
some parts later.

Take out the machine from the package to the intended
working location by hoisting with the belts. The load capacity
is about 300kgs at point E.

Method one: Use a sling. Carefully wrap the sling (E) around
the collar of the moveable jaw and motor mount.

Method two: Using lift rings. Attach lifting rings to three points
on the base of the machine. Attach a three-point sling with
grab or sling hooks to the lift rings.
Initial Cleaning

Machine is shipped with rustproof oil coating. Clean the rust
proof oil coating from all exposed metal surface. Then apply
oil / grease.

The stand of the cold saw has four mounting holes, two holes
on each side of the stand( ). The cold saw should be kept
level and rest solidly on the floor.

Please refer to the anchoring section above. When securing
the stand to the floor, apply even torque to the fasteners to
prevent distortion of the stand.
E
E
1
2