Hafco Metalmaster S829, Инструкция и каталог запасных частей

Страница: 17 / 31

16

Set the speed (C), read the speed displayed on the window
(H).

Set the coolant switch (B).

Grasp the control handle (G).

Press the trigger switch (F) to start.

Pull down the control handle (G). Apply a steady and
constant pressure.

After cut off

Raise control handle slowly

Press the stop button (D)

Use vise lever to open the vise

Remove or feed the work-piece forward

Repeat operation cycle, if necessary
The chopper is now ready to start work, bearing in mind that the CUTTING SPEED and the TYPE of
DISC – combined with a suitable descent of the head – are of decisive importance for cutting quality
and for machine performance.
When starting to cut with a new disk, in order to safeguard its life and efficiency, the first two or three
cuts must be made while exerting a slight pressure on the part, so that the time taken to cut is about
double the normal time.
Press the red emergency button (E) when there are conditions of danger of malfunctions in general,
so as to stop machine operation immediately.
1
1
0
0
R
R
O
O
U
U
T
T
I
I
N
N
E
E
A
A
N
N
D
D
S
S
P
P
E
E
C
C
I
I
A
A
L
L
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
THE MAINTENANCE SCHEDULE AS BEEN DIVIDED INTO DAILY, WEEKLY, MONTHLY,
AND SIX-MONTHLY INTERVALS. NEGLECTING THE MACHINE MAINTENANCE WILL
RESULT IN PREMATURE WEAR AND POOR PERFORMANCE.
10.1 Daily Maintenance
Make a general cleaning by removing dust and shavings from the machine.
Top off the coolant.
Inspect the disk/saw blade for wear.
Raise the head into a high position to reduce stress on the return spring.
Check that the shields and emergency stops are in good working order.
10.2 Weekly Maintenance
Thoroughly clean the machine including the coolant tank.
Clean and grease the vice screw and sliding surfaces.
Clean the housing for disk/saw blade.
Sharpen the saw teeth.
F
G