HAEMMERLIN MAXIAL PREMIUM, Инструкция по эксплуатации

Страница: 61 / 88

61
INSTALLATION AND USE OF ACCESSORIES FOR ANCHORING
AGAINST THE FACADE OF A BUILDING
ENCLOSURE CLAMP
The enclosure clamp allows the ladder structure of the hoist to be positioned and locked perpendicular to
the building façade in an opening of a window.
Adjusting the enclosure clamp:
- Unscrew the clamping handle (1).
- Remove the clip pin to release the sliding spur (2).
- Adjust the position of the sliding spur on the rod so that the space between the base of the clamping
handle and the fixed spur is slightly greater than the thickness of the wall of the enclosure where the
closure clamp (3) will be installed.
- Replace the clip pin to lock the sliding spur.
Installation of the enclosure clamp:
- Bring the enclosure clamp to the window frame (1).
- The support tube can rest on the apron wall of the window frame (1) and must be resting on the sill
of the frame in order to have the same vertical alignment reference for the next clamps on the upper
floors (2).
- Secure the enclosure clamp by turning the clamping handle with a properly shaped tube (3). The
minimum tightening torque to be applied to the clamping handle is 50Nm.
- Proceed in the same way to install the other enclosure clamps on each floor.
1
2
3
1
2
3