HAEMMERLIN MAXIAL PREMIUM, Инструкция по эксплуатации

Страница: 65 / 88

65
WINDOW MOORING CYLINDERS 0.70 to 1m and 1 to 1.70m
The mooring cylinder allows the ladder structure of the hoist to be positioned and locked perpendicular to
the building façade in an opening of a window. It is also used to position and lock the headboard of the
hoist in the opening of a window.
Adjusting the mooring cylinder:
- Remove the pin to release the sliding spur (1).
- Adjust the position of the sliding tube in relation to the pole so that the length of the mooring cylinder
is similar to the width of the enclosure (2). Allow enough space to insert the plywood wedges
between the enclosure and plate supports.
- Replace the pin to secure the sliding tube (3).
Installation of the mooring cylinder:
- Bring the mooring cylinder up to the enclosure and position it horizontally (1).
- Place marine plywood or equivalent wedges between the plates and the enclosure supports (2).
- Screw the clamping handle to block the cylinder (3). The minimum tightening torque to be applied to
the clamping handle is 50Nm.
Installation of the anchoring tubes for an installation perpendicular to the building:
- With the mooring cylinder installed horizontally in the doorway, the support tube (1) is installed
perpendicular to the façade using an orthogonal coupler (2).
2
1
3
1
2
2
3