Haas Automation VF Series, Книга управления

Страница: 79 / 127

72
January 2004
- INVOKE THE TAPPING CANNED CYCLE G84
1. JHCW and highlight the group titled 4. DRILL/TAP CYCLES.
2. JHCCW until Right Hand Tapping G84 is highlighted.
3. Press the WRITE key to have the control query you for the code on setting up tapping with G84.
Note that Quick Code defined a block to execute a tapping cycle at that present location. You will need to
enter in the appropriate speed and feed for this tapping cycle. You can add more X and Y tap cycle locations if
needed by selecting 6. DRILL/TAP/BORE LOCATIONS .
Note: We do not want to tap a hole at X0 Y0, which is the center of the bolt hole circle, so manually edit in an
L0 on the end of the G84 command line. This will ignore the G84 canned cycle until the next location.
- EXECUTE A CIRCULAR BOLT HOLE PATTERN
1. JHCW and highlight the group titled 6. DRILL/TAP/BORE LOCATIONS .
2. JHCCW and highlight the group titled BOLT HOLE CIRCLE Locations
3. Press the WRITE key to have the control query you for the code on positioning around a bolt hole
circle.
4. Enter in the numbers to answer all the questions in the lower left corner of the control screen, to
define all the commands necessary to position around to tap a Bolt Hole Circle with a G84 canned
cycle.
At this point you may decide to position the table forward to remove the part. You can do this in your program
with the following.
- Rapid Z axis coolant OFF
1. JHCW and highlight the group titled ENDING COMMANDS .
2. JHCCW until the RAPID Z Axis COOLANT OFF is highlighted.
3. Press WRITE.
This will query you for the location to Rapid the Z axis and turn OFF the coolant with an M09.
And finally, you can properly end your program with:
- Sending the machine home and ending the program
1. JHCW and highlight the group titled ENDING COMMANDS .
2. JHCCW until HOME Y and Z Axes is highlighted.
3. Press WRITE.
4. JHCCW and highlight the group titled
END PROGRAM and Reset M30 .
5. Press WRITE.