Haas Automation VF Series, Книга управления

Страница: 78 / 127

71
January 2004
By now you should have a good idea of how your program changes, after selecting a group item with the
handwheel and pressing WRITE. To save space we will not show you each display as a selection is made.
Instead we will list the remaining actions needed to finish drilling and tapping the 5 holes. The remaining
selections are very similar to what we have already done.
- CALL TOOL 2
1. JHCW to the group titled START UP COMMANDS then JHCCW and highlight the group item titled
CALL TOOL .
2. Press the WRITE key to have the control query you for a tool and enter in the number 2.
3. JHCCW and highlight the group item titled TOOL START UP Commands .
4. Press the WRITE key to have the control query you for defining all the commands to start up tool 2
in your program.
- INVOKE THE SPOT DRILLING CANNED CYCLE G83
1. JHCW and highlight the group titled 4. DRILL/TAP CYCLES.
2. JHCCW until Deep Hole Peck DRILL G83 is highlighted.
3. Press the WRITE key to have the control query you for the code on setting up drilling with G83.
Note that Quick Code defined a block to execute a spot drill cycle at that present location. You can add more X
and Y drill cycle locations if needed by selecting 6. DRILL/TAP/BORE LOCATIONS .
Note: We do not want to drill a hole at X0 Y0, which is the center of the bolt hole circle, so manually edit in an
L0 on the end of the G82 command line. This will ignore the G82 canned cycle until the next location.
- EXECUTE A CIRCULAR BOLT HOLE PATTERN
1. JHCW and highlight the group titled 6. DRILL/TAP/BORE LOCATIONS .
2. JHCCW and highlight the group titled BOLT HOLE CIRCLE Locations
3. Press the WRITE key to have the control query you for the code on positioning around a bolt hole
circle.
4. Enter in the numbers to answer all the questions in the lower left corner of the control screen, to
define all the commands necessary to position around to drill a Bolt Hole Circle with a G83 canned
cycle.
And now for tool 3, the 10-32 tap.
- CALL TOOL 3
1. JHCW to the group titled START UP COMMANDS then JHCCW and highlight the group item titled
CALL TOOL .
2. Press the WRITE key to have the control query you for a tool and enter in the number 3.
3. JHCCW and highlight the group item titled TOOL START UP Commands .
4. Press the WRITE key to have the control query you for defining all the commands to start up tool 3
in your program.