Haag-Streit VISUTRON 900 Touch, Руководство пользователя

Страница: 23 / 88

Daisy Chaining Multiple Visutron 900 Touch ’s
(continued)
Connecting with Internal Bluetooth
1. Tap Settings , located at the top right of the Controller screen.
2. Tap Ports on the Settings menu.
3. In the Port Settings panel, tap
Transfer
in the Port Selection column. Be sure that under Device,
VRx Transfer is selected. Refer to Figure IS-30.
4. Select Bluetooth (Internal) under Connection Type. Refer to Figure IS-30.
5. Tap
Discover
under Bluetooth Address. Refer to Figure IS-30.
6. Tap the Bluetooth address for the Visutron 900 Touch that the data will be transferred to, then tap Pair .
Note: The Bluetooth address is found in System Information, in the Service Menu. Refer to Figure IS-29.
Figure IS-29, Bluetooth Address
7. Repeat all the above steps for the Instrument 1 port on the Visutron 900 Touch that is having the data
transferred to it. Be sure that under Device, AutoPhor Receive is selected. Refer to Figure IS-31.
8. Repeat these connection steps for every Visutron 900 Touch in the chain.
Note: If the Bluetooth was successfully paired, “Connected” will appear in the upper right corner of
the panel on both Visutron 900 Touch units. “Connected” will not appear until both Visutron 900
Touch’s are configured. If “Failed” appears on either Visutron 900 Touch instruments, then repeat
the directions from step 3.
Note:
The last instrument in the chain only needs to have the Instrument 1 port configured, and not the
Transfer port.
Figure IS-31, Internal Bluetooth Receive Figure IS-30, Internal Bluetooth Transfer
Instrument Setup
(continued)
23
16243-101 Rev. G