Operation Manual – Multicast
H3C S5600 Series Ethernet Switches
Chapter 4 PIM Configuration
4-7
I. Neighbor discovery
PIM-SM uses exactly the same neighbor discovery mechanism as PIM-DM does. Refer
to
Neighbor discovery
.
II. DR election
PIM-SM also uses hello messages to elect a designated router (DR) for a multi-access
network. The elected DR will be the only multicast forwarder on this multi-access
network.
A DR must be elected in a multi-access network, no matter this network connects to
multicast sources or to receivers. The DR at the receiver side sends join messages to
the RP; the DR at the multicast source side sends register messages to the RP.
Note:
z
A DR is elected on a multi-access subnet by means of comparison of the priorities
and IP addresses carried in hello messages. An elected DR is substantially
meaningful to PIM-SM. PIM-DM itself does not require a DR. However, if IGMPv1
runs on any multi-access network in a PIM-DM domain, a DR must be elected to act
as the IGMPv1 querier on that multi-access network.
z
IGMP must be enabled on a device that acts as a DR before receivers attached to
this device can join multicast groups through this DR.
Join message
RP
DR
DR
Hello message
Register message
Source
Receiver
Receiver
Figure 4-3
DR election
As shown in
Figure 4-3
, the DR election process is as follows: