8
ACCESSORIES AND CONSUMABLES
Accessories
Consumables
Regularly check the wear condition of the protective tip, nozzle and electrode or in case of significant reduce of the
cutting speed.
It is advised to replace at the same time the nozzle and the electrode.
Plasma 40FV
Tip
Replace if cracked or damaged
040236
Nozzle
Clean if the inside of the nozzle is blocked or
dirty.
Replace if the opening is deformed or if the
size of the orifice has half increased.
040212
Diffuser
Replace if lateral orifices are bolcked.
040175
Electrode
To replace: if a significant cavity appears at
the electrode center.
040168
TROUBLESHOOTING
Anomalies
Causes
Remedies
At startup, the display shows ’Er1’
The device was turned on with the
trigger pressed
Release the trigger
At startup, the display shows ’Er2’
One or more buttons on the keypad are
pressed
Release the button(s)
At startup, the display shows ’- - -’
The machine is connected to an
unsuitable power supply (out of 85-265V
range)
Check the electrical system or generator
In operation, the display shows ’- - -’
The overvoltage protection is active.
The machine delivers no power and the
indicator (3) is on
The thermal protection of the Plasma
Cutter is active
Wait until the end of the cooling phase
The machine delivers no power and the
indicator (4) is on
The torch nozzle is not in place
Turn off the machine, check and replace the
consumables, turn on the machine
The display shows ’no Air’
The air pressure is too low
Check that the air supply is properly
connected to the machine, adjust the air
pressure
The machine delivers no power and the display
shows ‘Er3’
No contact between the electrode and
the nozzle
Turn
off
the
product,
check
the
consummables, check the electrode retracts
and returns easily. Try again.
The machine delivers no power and the display
shows ‘Er4’
The electrode cannot retract
Turn off the product, make sure that the
electrode can retract and return easily. Try
again
The display shows ’Er5’
The cutting cycle has stopped abnormally
Turn off the product, wait until the error
disappears, try again. If the error persists
return the product for inspection
Compass divider kit
(ref.
040205)
For circular cutting up to
134 cm diameter.
Provided with 3 axes:
magnetic, with center pin,
with thread
Trolley
(
Ref. 040199)
For a comfortable use and be
at the advised height
For optimizing the cutting
performances and increase
the nozzles life-time.
