Guldmann GH2, Руководство по установке

Страница: 61 / 109

A
B
E
F
D
C
©
Guldmann
GB
-1394/11/08
6
4.
e
le
ct
rI
ca
l
co
n
n
ec
tI
o
n
Installation of the Combi-lock
Motor unit is installed as described on page 63 .
Installing the safety lock on fixed rail
• The motor unit with tongue and the safety lock for the
fixed rail are pushed together into the T track in the Mini
rail .
• The safety lock should be installed so that its edge is
flush with the front edge of the rail .
• Fasten the safety lock with two M4 x 10 locking screws .
• Use the safety lock as a drill gauge and hold it precisely
in position while drilling . A screw clamp can also be
used to keep the safety lock in position while drilling .
Bottom of safety lock must fit tightly against bottom of
rails .
• Drill the holes and make the M4 threads . Clean up
components and mount the screws .
• Tighten the motor house . Ensure that the sliding bolt is
pulled no more than 2 mm (
3
/
16
") back from the front
edge of the rail when it is mechanically pulled back
to its rearmost position .
• Install bracket for Combi-lock . Before finally fastening
the bracket, check that the rail is level, both horizontally
and vertically . If necessary, adjust the bracket .
A . 100 mm (4")
B . std . 100-400 mm (4" – 16")
B . max 1350 mm (54")
C . 200 mm (8")
D . 58 mm (2
5
/
16
")
E . min 115 mm (4
9
/
16
")
F . min 255 mm (10
5
/
16
")
Installing the safety lock on traverse rail
• Loosen the M8 nuts in the T track plate so that the
safety lock can be pushed into the T track of the rail .
• The safety lock must be level with the track end .
• When the safety lock has been correctly installed,
the two M8 nuts can be tightened .
• Check that there is a space of minimum 1 mm (
1
/
16
")
from the activation pin in the T track to the bottom of
the T track .
• Fasten the safety lock with one M4 x 10 locking screw .
• Use the safety lock as a drill gauge .
• Drill the holes and make the M4 threads . Clean up
components and mount the screws .
Important
After installation has been completed, check that the locks
work in combination, i .e . they open and close correctly
individually .
All parts have been lubricated from the factory . Do not
lubricate or grease any components or rails
Combi-lock
CL electrically operated