GUDEL CP 3-5 V2, Руководство по эксплуатации

Страница: 57 / 350

7.4 Setup, fastening
7.4.1 General
The following describes the steps for setting up and fastening the product.
WARNING
Heavy components
Components can be very heavy. Improper handling can cause severe or fatal
injuries!
• Use appropriate lifting units
• Use suitable means to secure the components against tipping over
• Only remove the safety devices after the product has been completely as-
sembled
Prerequisites Before you set up the product at the installation site, the requirements as per
chapter
Ü 2
57 must be fulfilled.
Tightening torques
Unless otherwise indicated, adhere to the tightening torques of Güdel.
Ü
Chapter 14,
2
286
7.4.2 Prerequisites
Base
The base must comply with the requirements of the intended application. For
information on the load per unit area and the surface properties, please refer
to the layout or the documentation for the complete system. The assessment
of the load capacity of the floor (concrete, reinforcement, payload, etc.) must
be carried out by a structural engineer or architect. Güdel is not responsible
for the load propagation within the foundation.
Lifting units
Lifting units are required for setting up and installing the product. Make sure
that appropriately dimensioned devices (crane, etc.) are available.
Lines
The supply lines have to meet the requirements of the application. For infor-
mation on the required capacities, please consult the documentation for the
complete system.
Commissioning OPERATING MANUAL CP 3-5 V2
9007202252815371_v1.0_
EN-US
57